The Little Wood Shop 2019

[icefisher47]

Turning Tiny!
Making a couple miniature “Un Christmas trees” for my daughter and my Son’s wife.










Tiny birdhouse, snowmen, trees, ornaments and Santas so far. A lot more to go. 1000 little pieces…again!

Nice job

[Raquettedacker]

🤣🤣🤣

[gotagetm]

Hahaha

[rgfixit]

Been so busy with Christmas planning and building that I didn’t get back to this.





All toll there were 288 individual pieces to make the two little Christmas trees.

Didn’t get a pic of the finished product. Was really anxious to put the project to bed. I’ll get some at Christmas and post.

[MILLERMANKT]

Those are awesome Bob , I wish i had the hands to do that.
 Dom , That's a beautiful pallet.

[MILLERMANKT]

 Some of the cheese slicing boards I'm making for Xmas gifts.  Starting some charcuterie boards tomorrow to go with them

[rgfixit]

Very nice! Almost whipped up a charcuterie board yesterday for our family party tomorrow. Decided to wait. Too much cooking to do to take the time right now.

[iceman260]

Nice work guys really like that pallet.

[Raquettedacker]

I could never compete with Bob’s incredible craftsmanship and all your guys work so I start simple..😎😎✌️✌️

[KingPerch]

Good work guys!! Love the pallet, Dom!!😁




Spending some time in my shop the last few days making some Christmas gifts. Making a dozen of these trees. Fun little project. They will get a few coats of Bush’s finish on them next. I’ll post up the finish product in a day or so. Much less hectic than running job sites.😁

[rgfixit]

Pretty cool KP!

I’ve been turning bird houses for my Bride. I do one a day for the 12 days of Christmas. I’ll make a few for gifts as well.

[KingPerch]

Thanks, Bob!

Question….where can we find 3 fluted flush cut 1/4” x 1/4” shank router bits… price isn’t an object. I’ll explain another time. Got a shop that looks like a bomb went off in it today. 😂

[rgfixit]

Lowes most likely would have that in Bosch. Don’t buy the black and decker junk. If you want really good try woodcraft or rockler. They probably have Freud bits.

[KingPerch]

Lowes most likely would have that in Bosch. Don’t buy the black and decker junk. If you want really good try woodcraft or rockler. They probably have Freud bits.

Thanks. I asked because I’m cutting lumber from templates. Rough cut the parts with bandsaw, then finish with flush trim bit. The double flute works but not enough smooth cutting. I’ll check out your suggestions.

[62 & Done]

Lowes most likely would have that in Bosch. Don’t buy the black and decker junk. If you want really good try woodcraft or rockler. They probably have Freud bits.

    I'm not sure what brand it would be but I'm sure Ace hardware would have one