FishUSA.com Fishing Tackle

Author Topic: Technical Difficulties....  (Read 3348 times)

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #15 on: Sep 18, 2020, 05:07 AM »
Thanks for the thoughts KP. I’m pretty sure it’s just timing. I’ll find out in an hour or so.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

Fishin-Mission

  • Jr. Member
  • **
  • Posts: 125
Re: Technical Difficulties....
« Reply #16 on: Sep 18, 2020, 07:53 AM »
What about the low idle jet, is it clogged or fowled from using the ethanol enhanced fuel?  I would be checking the carburator.

Mac Attack

  • Sr. Member
  • ***
  • Posts: 10,210
Re: Technical Difficulties....
« Reply #17 on: Sep 18, 2020, 08:04 AM »
What about the low idle jet, is it clogged or fowled from using the ethanol enhanced fuel?  I would be checking the carburator.

Bob stated the below in an earlier post.  Unsure what he means however.

"I’ve burned regular gas in it since the first time i filled the tank. It doesn’t care about ethanol."

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #18 on: Sep 18, 2020, 09:14 AM »
Trapper made a comment about using ethanol gas in it.

Anyway, I found the problem. A while back I installed a digital tachometer. It has a lead that wraps around one of the plug wires to sense RPMs. This morning i splashed the boat and it was doing the exact same thins as before. One cylinder was dropping out at low idle.

Something in my brain prompted me to try disconnecting that tachometer lead. I did and the motor ran perfectly. Idles down with no problems. I even trolled for a good hour with it. No issues at all.

Must be it interfered With the electronic ignition in some way. I’m going to the dealer tomorrow to get 2 new plug wires. They’re OE and 36 yers old. I guess i can replace them just because.

Occam’s Razor strikes again.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

lowaccord66

  • Sr. Member
  • ***
  • Posts: 6,273
Re: Technical Difficulties....
« Reply #19 on: Sep 18, 2020, 09:34 AM »
Good stuff RG.  Waiting to catch a break at lunch to get the new starter and solenoid in. 

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #20 on: Sep 18, 2020, 01:20 PM »
$42 later it has new OMC plug wires.....which I had to put together.

Must be platinum coated wire or something.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

Mac Attack

  • Sr. Member
  • ***
  • Posts: 10,210
Re: Technical Difficulties....
« Reply #21 on: Sep 18, 2020, 01:54 PM »
$42 later it has new OMC plug wires.....which I had to put together.

Must be platinum coated wire or something.

Rg

The first ones lasted 35 yrs Bob.
If these perform the same you and I won’t be here to see it.

Good job!

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #22 on: Sep 18, 2020, 04:01 PM »
That’s a fact Jack!

It’ll be a couple days till I can do another test run. No way I’m launching in 30 degree weather. Hands cant take it anymore.

But, I’m confident.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

lowaccord66

  • Sr. Member
  • ***
  • Posts: 6,273
Re: Technical Difficulties....
« Reply #23 on: Sep 18, 2020, 07:11 PM »
My issue is fixed as well.  Soleniod failed.  Replaced both and now I'm good to go.  It is going to be a cold start tomorrow so debating waders vs boat.

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #24 on: Sep 18, 2020, 07:28 PM »
I’ll be on shore tomorrow...somewhere...don’t  know where just yet. Haven’t missed a day since May. Don’t intend to start now.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

KingPerch

  • Sr. Member
  • ***
  • Posts: 7,463
Re: Technical Difficulties....
« Reply #25 on: Sep 18, 2020, 07:37 PM »
Good luck, Bob!!
“I’ve never met a Perch I didn’t like!! 😎

Time spent fishing is not deducted from one’s life span

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #26 on: Sep 18, 2020, 07:54 PM »
Thanks bud!

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

lowaccord66

  • Sr. Member
  • ***
  • Posts: 6,273
Re: Technical Difficulties....
« Reply #27 on: Sep 18, 2020, 09:13 PM »
Good luck.  I decided to go with shore as well. Don't have the energy to deal with trailering and launching.  Windy too.  Trout it is.

trapper2000

  • Sr. Member
  • ***
  • Posts: 9,608
  • live the dream...........wear it!!!
Re: Technical Difficulties....
« Reply #28 on: Sep 19, 2020, 07:06 AM »
glad ya  got it  worked out man .... i had a  issue  with my  ice auger  getting it ready  for winter   again carb  was  nasty  cleaned it  but still wasn't running great  looked and ordered a new  carb off  e bay  15 bucks  and  2  screws and it runs like new again ...... good luck and get those fish
you can destroy buildings  you can't  destroy the  american spirit

rgfixit

  • MFF Mod Team
  • Sr. Member
  • ****
  • Posts: 12,581
Re: Technical Difficulties....
« Reply #29 on: Sep 19, 2020, 05:17 PM »
Shore fishing today. Slow as I figured it would be with this high pressure system on us.

But, I caught some fish anyway.

Rg
If you lend someone $20 and never see that person again, it was probably worth it.

 



Iceshanty | MyFishFinder | MyHuntingForum
Contact | Disclaimer | Sponsor
© 2004- MyFishFinder.com
All Rights Reserved.